Ethics Archery Outsert system

Ethics Archery Outsert system

American made, Veteran owed. Ethics Archery’s Outsert post and outserts system eliminates the misalignment of your outsert.  There are two outsert options, Aluminum outsert at 25 grains and Stainless steel outsert at 75 grains. The post has is a two section cut away. Starting at 40 grains and breaking away to 30 then 20 grains allowing you to customize your FOC.

Outsert installation instructions:

  •  Dry fit outsert after shaft has been cut to the proper length. Sand the end of the shaft with a fine grit sand paper if needed. Sanding will also help the outsert bond to shaft better. Do not sand the shaft too much, you want the outsert to fit snug.
  • Wipe the shaft with a clean rag or paper towel. No cleaner is needed.
  • Dry fit the post into the arrow. Then pull it back out and glue the post in.
  • Slide the outsert over the top of the post and shaft. Then screw in your field point or broad head. Spin test to ensure proper alignment.
  • You do not need to glue the outsert onto the shaft but I would suggest gluing it onto the shaft. Apply the glue evenly around the shaft. Spin the outsert slowly as you slide it onto the shaft. This will help to ensure the glue covers the entire shaft and the inside grooves of the outsert.  Screw in a field point our broadhead to hold the outsert in place.
  • Bohning Blazer bond cure time is 2 hours. Insert Iron is 48. Do not shoot your arrows until the proper cure time has elapsed. If using Bohning Blazer bond the clamp time is only 20 seconds so you got to be quick.  Insert Iron gives you more time to adjust the outsert .


    © 2018 Five in the Eye Productions Inc.  All rights reserved.